Chevy Silverado Tire Pressure Sensor Reset.

This button features a check mark, and is at the lower end of the panel. It may take several attempts at getting all of your sensors reset. The tire pressure monitor (tpms) system uses the passenger door module (pdm), the body control module (bcm), the exterior lamp switch, the 4 radio frequency transmitting pressure sensors in the tire valves, and the serial data circuit to perform the sensor learn mode functions.

There Is No Way In Heck I Am Going Spend Any Money On Something Like That.

Start the vehicle but give it about 20 mins or so to completely reprogram the system. Use a tire pressure gauge to check the tire pressure. I had the tpms trip pressure reset to 50psi in all four tires for a whopping $15 at the dealer.

Tighten The Torx Screw To 1.3 N.m (11.5 Lb In).

Adjust the tire pressure in all four tires recommended on the tire placard; How to reset tire pressure sensor chevy silverado 2013 2021. 3.scroll to the tire pressure screen using the scroll wheel on the turn signal stalk.

Let’s Explore How To Reset Tire Pressure Sensor Step By Step.

How to reset tire pressure sensor chevy silverado 2013. Once your tires are properly inflated, the tire pressure light should turn off, however, if it remains on, there are a few additional steps you can take to turn it off: The tire monitor service light will come on instantly if the tire pressure is below 25 psi.

Push And Hold The Set/Reset Button Horn Will Chirp Twice, Dic Displays Tire Learning Active Use The Tool To Activate The Left Front Sensor

Then inflate again and drive for a couple of minutes at 15 mph to manually calibrate the sensors. Bypass tpms system with or without tpms. Start the car and wait for about 20 minutes for the tire pressure sensor to refresh.